Monitor, Digital Area, 90-260 VAC - Built-in GM Gamma Detector display in mR/hr

The Digital Area Monitor with built-in GM Gamma Detector provides continuous gamma radiation monitoring of rooms where radionuclides are received, stored, or dispensed, and in waste management areas where there is the possibility of radioactive contamination. The monitor is wall-mountable.

With built-in GM Gamma Detector for continuous monitoring

Detects gamma radiation
LOW and HIGH alarms with yellow and red lights, adjustable audible tones
0.1 mR/hr - 1000 mR/hr or 1 µSvh - 9999 µSv/h
Detector failure light and tone to signal detector overload or instrument failure
Threshold adjustment from 2 to 100 mV
Battery continuously trickle charges when unit is operating and connected to wall current
Low battery warning

Specifications

Internal Detector: Halogen quenched GM gamma detector, sensitivity: 1000 cpm/mR/hr (Cs-137 gamma), energy response (60 keV - 3 MeV): within ±25% of true valueDisplay: Four-digit LED display with 0.8" (2 cm) character height
Display Range: 000.0-9999
Display Units: Available in mR/hr
Linearity: Reading within ±10% of true value with detector connected
Response: Typically three seconds from 10% - 90% of final reading
Status: (Green light) instrument functioning properly
Alarm: Low alarm - indicated by yellow light and slow beep (one per second) audible tone (can be set at any point from 0.0 - 9999); high alarm - indicated by red light and fast beep (4 per second) audible tone (can be set at any point from 0.0 - 9999); NOTE: Audible indicators can be configured as a single beep if desired
Det Fail: Detector overload, no count from detector, or instrument failure - indicated by red light and audible tone (greater than 68 dB at 2 feet)
Low Bat: (Yellow) indicates less than two hours of battery power remaining
High Voltage: Adjustable from 200 - 2500 volts
Threshold: Adjustable from 2 - 100 mV
Dead Time: Adjustable to compensate for dead time of detector and electronics (can be read on display)
Overload: Senses detector saturation (indicated by display reading "-OL-")
Overrange: Indicates radiation field being measured has exceeded counting range of instrument (indicated by display reading "- - - -")
Data Output: 9 pin connector providing 5 decade logarithmic output,RS-232 output, signal ground connection, FAIL and ALARM signals (current sink), and direct connection to battery and ground
Calibration Controls: Accessible from front of instrument (protective cover provided)
Power: 90-260 VAC auto ranging or battery power
Battery Life: Typically 48 hours in non-alarm condition; 12 hours in alarm condition
Battery Charger: Battery is continuously trickle charged when instrument is connected to line power and turned on
Battery Dependence: <3% change in readings to battery endpoint
Construction: Wall mount aluminum housing with ivory polyurethane enamel paint
Dimensions: 7.4" h x 9.7" w x 2.5" depth (18.7 x 24.6 x 6.4 cm)
Weight: 6.7 lb (3 kg)

SKU	106773
MFR Number	051-275
Manufacturer	MIRION TECHNOLOGIES (Capintec)
UOM	EA
Packaging	EACH
BAAN SKU	409601
Short Description	Monitor, Digital Area, 90-260 VAC - Built-in GM Gamma Detector display in mR/hr